Mi Account Unlock File, and FRP Unlock File Download. From this file, you can bypass the Xiaomi models FRP and mi account without doing full flash. This flash file is in the MBN File, which describes how to flash and driver Install from Xiaomi FlashTool. Here is how to Unlock Redmi Phone with an Unlock File, which is given below in full detail. How to Flash Manual.
Mi FlashTool - Download Mi Driver - Download
- Mi_8_Deppir – Download
- Mi_8_Lite_Platina – Download
- Mi_8_Pro – Download
- Mi_A2_Jasmine – Download
- Mi_A3 – Download
- Mi_Max_2 – Download
- Poco_F1 – Download
- Redmi_3S_3X – Download
- Redmi_4A – Download
- Redmi_4i – Download
- Redmi_4X – Download
- Redmi_5 – Download
- Redmi_5A – Download
- Redmi_6 – Download
- Redmi_6A – Download
- Redmi_6Pro – Download
- Redmi_7 – Download
- Redmi_7A – Download
- Redmi_8A – Download
- Redmi_K20 – Download
- Redmi_K20_pro – Download
- Redmi_Note_3 – Download
- Redmi_Note_4 – Download
- Redmi_Note_5 – Download
- Redmi_Note_5_Pro – Download
- Redmi_Note_6_Pro – Download
- Redmi_Note_7 – Download
- Redmi_note_7_Pro – Download
- Redmi_Note_7S – Download
- Redmi_note_8 – Download
- Redmi_note_8_Pro – Download
- Redmi_Y1 – Download
- Redmi_Y2- Download
- Redmi_Y3 – Download
- Redmi-go_tiare – Download
How To Use Mi Account Unlock File:
Download Xiaomi Redmi Note 4 Flash File And Install Install Driver, Charge the phone 30% before flashing.
- Download all files from the links given above.
- Install the given Xiaomi flash tool, the USB driver of the phone is included in the flash tool
- Then extract the flash file from the zip file.
- Extract from the zip file after 7zip setup again.
- If the 7zip setup is not installed on your computer then install it. (7zip Link)
- After that Run the Xiaomiflash.exe From the Desktop and select flash in it
- After that click on the option of the above selection in the tool and select the “image” folder in the folder where your flash files are.
- If you are flashing in Fastboot mode, select the “firmware” folder.
- After selecting the firmware, connect the phone to the computer.
- To get the phone into the EDL model, find and jump the EDL point and connect the data cable with the phone.
- After that select “Clean All” in the option given below and click the Refresh button which will show the com port in the tool.
- After that click on the flash button, and the flash will start.
Note: During flashing, do not remove the data cable from the phone, otherwise the phone can go into dead mode.